Installation - Strong SM-RAZOR-F-M Installation Manual

SM-RAZOR-F Instruction Manual

Installation

Step 1: Mount the Wall Bracket Assembly
Mounting on a Stud Wall
A. Pre-drill holes into two wood studs
using a 3/16" drill bit. Be sure to drill into
the center of the studs at least 2-1/2"
deep. The use of a stud finder is highly
recommended.
B. Insert the Lag screws (A) into holes
through the Wall Plate and tighten.
(Figure 1).
WARNING: Tighten bolts so that wall
plate is firmly attached, but do not over-
tighten. Over-tightening can damage
the bolts, greatly reducing their holding
strength.
Mounting on a Concrete Wall
WARNING:
When installing wall bracket on cinder block:
• Verify first that you have a minimum of 1-3/8" of concrete thickness
to be used for the concrete anchors.
• Do not drill into mortar joints! Be sure to mount in a solid part of the
block, generally 1"minimum from the side of the block.
• Cinder block must meet ASTM C-90 specifications.
• It is suggested that a standard electric drill on slow setting is used to
drill the hole instead of a hammer drill to avoid breaking out the back
of the hole when entering a void or cavity.
• Concrete must be 2000 psi density minimum. Lighter density
concrete may not hold anchors.
• Make sure that the supporting surface will safely support the
combined load of the equipment and all attached hardware and
components.
pg.4
Figure 1
www.snapav.com Support: 866.838.5052