Table of Contents
Advertisement
3.
Lift the display and hook the two top bolts in grooves on top of the Mounting Head. Bottom studs will slide into roll
adjustment slots.
4.
Once in position, reinstall wing nuts and secure the Adapter Plate to the Arm Assembly Head Mount.
Cable Cover Attachment
1.
Route electrical and data cables along the Arm Assembly and secure in place using the provided Cable Covers (Figure 6).
NOTE: Ensure enough slack is provided to allow for vertical and horizontal movement before attaching the Cable Covers.
Optional Adhesive Felt Pad
Included with the hardware pack are Adhesive Felt Pads for cushioning impact of the arm against the wall when collapsing the
mount. Place the pads on the opposite side from the Cable Covers where possible impact point with wall will occur (Figure 7).
Mount Head
Wing Nuts
Small
Adhesive Felt Pads
Display Panel
Adapter Plate
Figure 5
Cable Covers
Figure 6
Figure 7
6
Arm Assembly
Head Mount
Wing Nuts
Large
Advertisement
Table of Contents
