Table of Contents
Advertisement
Installing Wall Plate Cover
Included with the hardware pack are two halves of the wall plate cover assembly. Put the wall plate cover assembly
together around the arms and slide onto wall plate.
Wall Plate Cover
ADJUSTMENTS
Tilt Adjustment
1.
Loosen Tilt Lever on the side of Mount Head (only enough to allow controlled adjustment) (Figure 8).
2.
Adjust tilt.
3.
Tighten locking Tilt Levers.
NOTE: Once the tilt levers are locked, the position of the levers can be adjusted without loosening or tightening the unit
by pulling the levers outward and then repositioning them to a vertical, less obtrusive position.
Horizontal Adjustment
1.
To adjust the horizontal angle of the display, first slightly loosen the top two screws on back side of the Arm Assembly
Head Mount using the provided Allen Key. Then firmly hold opposite corners of the display and gently turn it into the
desired position. When level, re-tighten screws to lock in position (Figure 8 and Figure 9).
15° 6°
Tilt Lever
Adjustment Wingnuts
Horizontal Level
Figure 8
7
Wall Plate Cover
Figure 9
+/- 5°
Advertisement
Table of Contents
