Transportation; Storage - Husqvarna 120 Mark II Operator's Manual

Use a flat file and depth gauge tool to adjust
the depth gauge.
1. Put the depth gauge tool above the saw
chain. Detailed information regarding how
to use the depth gauge tool will be found
on the package of the depth gauge tool.
2. Use the flat file to file off the tip of the depth
gauge that protrudes through the depth
gauge tool. The depth gauge setting is
correct when you no longer feel resistance
as you draw the file along the depth gauge
tool.
To tension the saw chain
Note:
Check the tension of a new saw chain
frequently during its running-in period.
1. Loosen the guide bar nuts that hold the
clutch cover. Use the combination wrench.
(Fig. 81)
2. Tighten the guide bar nuts by hand as tight
as you can.
3. Lift the top of the guide bar and extend the
saw chain by tightening the chain
tensioning screw. Use the combination
wrench. Tighten the saw chain until it does
not hang down from the bottom of the
guide bar. (Fig. 82)
4. Tighten the guide bar nuts using the
combination wrench and lift the tip of the
guide bar at the same time. (Fig. 83)
• Put the transportation guard on the cutting
attachment during transportation to prevent
injuries.
• Always put the product away safely when
not in operation. Leakages and fumes from
the product can touch sparks, naked
flames from electrical equipment, electrical
mowers, relays/switches, boilers and more.
• Always save fuel in an approved container.
20
5. Make sure that you can pull the saw chain
round freely by hand and that it does not
sag. (Fig. 84)
To lubricate the cutting equipment
To do a check of the saw chain lubrication
Do a check of the chain saw lubrication each
time you refuel.
1. Start the product and let it run at 3/4 speed.
Point the nose of the guide bar at a light
color surface almost 20 cm (8 in) away.
2. After 1 minute of running, a line of oil
shows on the light surface.
3. If you cannot see the line of oil after 1
minute, clean the oil channel in the guide
bar. Clean the groove in the edge of the
guide bar. Make sure the guide bar nose
sprocket turns freely and that there are no
blockages in the lubrication hole. Clean
and lubricate the tip sprocket.
4. Start the product and let it run at 3/4 speed.
Point the nose of the bar at a light color
surface almost 20 cm (8 in) away.
5. After 1 minute of running, a line of oil
shows on the light surface.
6. If you cannot see the line of oil after 1
minute, speak to your approved dealer.

Transportation

• Make sure that the product can not move
during transportation.

Storage

• Empty the fuel tank and the chain oil tank
when the product is in storage for longer
periods of time. Discard used fluids
correctly.
• Put the transportation guard on the cutting
attachment during storage to prevent
injuries.
658 - 008 - 10.02.2020