Assembly - Husqvarna 120 Mark II Operator's Manual

light. Make sure that the storage area does
not contain an open flame.
• Only use approved containers when you
move the fuel or put the fuel into storage.
• Empty the fuel tank before long-term
storage. Obey the local law on where to
dispose fuel.
• Clean the product before long-term
storage.
• Remove the spark plug cable before you
put the product into storage to make sure
that the engine does not start accidentally.
Safety instructions for maintenance
• Disconnect the spark plug before doing
maintenance on the product, not including
carburetor adjustments.
• Have all product servicing done by an
approved dealer, not including the tasks in
Maintenance on page 17 .
• Make sure the saw chain stops moving
when the throttle trigger is released.
• Keep the handles dry, clean, and free from
oil or fuel mixture.
• Keep caps and fasteners correctly
tightened.
• Replacement components that are not
approved or the removal of safety devices
can cause damage to the product. This can
WARNING:
the safety chapter before you
assemble the product.
To assemble the guide bar and saw
chain
1. Remove the spark plug cap from the spark
plug during assembly to prevent an
accidental start.
2. Remove the bar nuts and the sprocket
cover. Remove the transportation guard
(A). (Fig. 37)
3. Put the guide bar above the bar bolts.
Steer the guide bar to its most rear
position. (Fig. 38)
658 - 008 - 10.02.2020

Assembly

Read and understand
also cause possible injury to the operator
or bystanders. Only use accessories and
replacement parts as recommended. Do
not change your product.
• Keep the saw chain sharp and clean for
safe and high performance.
• Obey the instructions for lubricating and
changing accessories.
• Examine the product for damaged parts.
Before more use of the product, make sure
the damaged guard or part operates
correctly. Examine for broken or incorrectly
aligned parts, and parts that do not move
freely. Examine for other conditions that
can have an effect on the operation of the
product. Make sure the product is correctly
installed. A guard or other damaged part
must be repaired or replaced by an
approved dealer unless written in the
operator's manual.
• When not in operation, keep the product in
a dry, high or locked area away from
children.
• During transportation or storage of the
product, use a transportation guard or case
to move the product.
• Do not use waste oil. Waste oil can be
dangerous to you and can cause damage
to the product and environment.
4. Put on protective chainsaw gloves.
5. Lift the saw chain above the drive sprocket
and engage it in the groove on the guide
bar. Start on the top edge of the guide bar.
(Fig. 39)
6. Make sure that the edges of the cutting
links are turned forward on the top edge of
the guide bar.
7. Assemble the sprocket cover and steer the
chain adjuster pin to the hole in the guide
bar.
8. Make sure that the drive links of the saw
chain fit correctly on the drive sprocket.
Also make sure that the saw chain is
correctly engaged in the groove in the
guide bar.
13