Advertisement
exchanger)
Tightening torque
Gear oil drain/filler plug - GL differential
Plug
With the introduction of the new system of
gearbox oil with single oil heat exchanger it
becomes necessary to adapt the pump
(AV
8174) element 01 (with short spout) in
order to perform the operation, proceeding as
follows.
Fit a piece of flexible hose (3), of suitable
diameter and measuring 350 mm in length,
on the spout (4), and fasten with the indicated
screw collar Part No. 13000190 (Diam.10-
16x7 mm).
Tighten the plugs (1) and (2).
Tightening torque
Plug
Using the pump
short spout), adapted as previously
described, aspirate the specified oil from a
newly opened container.
Using the pump
container for collecting excess oil, fill with 3.5
litres via the level check/filler hole, with the
piece of hose (3).
Fill with half of the quantity indicated, wait a few
minutes for the fluid to settle, then gradually
finish filling, until oil overflows from the
check/filler hole.
The quantity of oil required may vary slightly
relative to the amount indicated for filling the
tank when empty; this is due to unavoidable
pooling within the system. Fill gradually.
Nm
25 Nm
Nm
25 Nm
(AV
8174) element 01 (with the
(AV
8174) element 01 and a
Class
B
Class
B
Advertisement
