FLIR T Series Quick Start

Touch screen stylus
SD storage
Measure
Info
1. MEMORY:
 Insert an SD memory card the slot under the rubber cover on top of the camera.
2. POWER:
 Insert a charged battery into the battery bay on the bottom of the camera.
3. START:
 Press the Power button, below and to the right of the LCD viewing screen. Press and hold to turn off.
4. FOCUS:
 Slide the Focus Button (AF) on front of the hand grip either to the left or right to manually focus the image or
push straight in and release to auto focus.
5. AUTO ADJUST:
 Pressing the Auto/Manual button will toggle between Auto mode and Manual mode. The letter "A" or "M" will
appear in the upper right portion of the image viewing screen.
6. MANUAL ADJUST:
 Press the Auto/Manual button until the "M" appears in the image viewing screen.

Move the Joystick up to l raise the level and down to lower the level.

Move the Joystick to the left to increase the span and to the right to decrease the span.

As level and span is adjusted an indicator will appear to the left of the Palette bar to indicate the direction of
adjustment.
© 2011 The Snell Group / 322 N. Main St. / Suite 8 / Barre, VT / 05641 / 800.636.9820 / www.thesnellgroup.com
QuickStart:
On/Off
Setup
Recall
Mode
Power
Flir T/B Series T/B200-400
Joystick
Auto/ Manual
Save/Preview
Focus Lens Cap
Flir T/B-Series Page 1