Table of Contents
Advertisement
Turn on the heater by the power switches on the side of the heater, once
on these will illuminate. For the maximum heat setting both switches
should be on.
To reach the desired room temperature turn the thermostat anti-clockwise
until the thermostat "clicks off" and the lights on the switches are seen to
go out. The heater will keep the air temperature in the room at the set
temperature by switching on & off automatically.
NOTE: The heater does remain hot / warm for some time after the unit has
been switch off, please handle with care.
When used in a workplace, this product should be safety-tested yearly by a
qualified electrician (PAT Tested). We recommend that it is PAT tested regularly
when used in a domestic environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory for
new buildings).
At time of going to press, the average cost of electricity is £0.145 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill.
At this cost, the EH1710 / EH1710BLK will cost £0.29 per hour to run with the
thermostat set to its maximum.
If the thermostat is used to regulate the temperature, the operating costs will be
lower, depending on the room temperature.
2580
PAT TESTING
OPERATING COSTS
5
Ver. 3 – 0918
Advertisement
Table of Contents
