Advertisement
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product for
future reference.
BEFORE USE
You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
INSTALLATION
Attaching the feet.
Clip the front foot (the one with rounded corners) on to the plastic plate at the base
of the front panel (The front is the end that has the controls)
Clip the rear foot (the one with square corners) on to the base of the rearmost fin.
Check that the radiator stands in an upright position and is stable. This radiator is
fitted with a tip over switch and will only work when it is an upright position.
Leave for one hour before switching on, to allow all the oil to drain to the
bottom.
PAT TESTING
When used in a workplace, this product should be safety-tested yearly by a
qualified electrician (PAT Tested).
We recommend that it is PAT tested regularly when used in a domestic
environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least once
every 10 years or at every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must
be inspected at least once every 5 years.
It is recommended that all buildings be fitted with smoke alarms (it is mandatory for
new buildings)
Page 2
Advertisement
