Charging The Handheld Pc; Logging On To Microlab Mobile For The First Time - Agilent Technologies 4100 ExoScan FTIR Operation Manual

Getting Started

Charging the handheld PC

To connect the handheld PC to an AC power source for charging
the battery:
1
2
3
Alternatively, if purchased, place the PC in the optional handheld
charging cradle. For more information on the operation of the
handheld PC, see the supplied Socket User Manual.

Logging on to MicroLab Mobile for the first time

As mentioned above, the 4100 ExoScan FTIR systems are supplied
with the Agilent MicroLab Mobile software already installed on your
system.
In addition, the handheld PC is provided with a shortcut to the
MicroLab Mobile software already installed in the Start menu.
To start the software:
1
Upon initial launch of the system, the MicroLab Mobile software
automatically loads and a MicroLab application splash screen
appears briefly showing software version, copyright and trademark
information.
The software will launch and display a logon screen.
If the 4100 ExoScan FTIR instrument has not been turned on first, you will
NOTE
receive an 'Instrument Failed to Initialize' warning message on the handheld PC.
If this happens, tap OK, power-cycle the 4100 ExoScan instrument, and restart
the MicroLab Mobile application.
20
Connect the USB cable to the handheld PC.
Connect the PC AC power cable to the 'Y' connector of the USB
cable.
Connect the handheld PC power cable to the AC power source.
Tap Start then tap the MicroLab Mobile icon.
Agilent 4100 ExoScan FTIR Operation Manual