Ac Power - Agilent Technologies 4100 ExoScan FTIR Operation Manual

Getting Started
4
5
Depending on temperature and age of the battery, the system should
generally operate for a period of up to four hours on battery power.
To continue using your system while exchanging the battery, you
must have the AC power cable connected between the 4100 ExoScan
FTIR housing and an AC power source.
To remove the battery from the compartment, simultaneously
depress the button on both sides of the battery compartment door
and rotate the door open. Then pull on the black plastic tab to slide
the battery out of the 4100 ExoScan FTIR housing.
It is highly recommended that the battery not be stored in the 4100
ExoScan FTIR unless connected to the main power source for
charging. Similarly to a laptop PC battery, the 4100 ExoScan battery
will slowly discharge when left plugged into the system.
WARNING Electrical Shock Hazard
Avoid shock hazard. Never allow liquid to run into the 4100 ExoScan FTIR
battery compartment.

AC power

The 4100 ExoScan FTIR is provided with an AC power cord and
external power supply 15 volt DC converter. This can be used to
operate the 4100 ExoScan over extended periods of time or to charge
the 4100 ExoScan battery. The 4100 ExoScan uses a single docking
style connector for both line power and USB communication to an
external computer. A 'Y' cable is included for this purpose. Including
the 4100 ExoScan USB cable, there are a total of four cords to make
these connections. In addition, a cable to connect the handheld PC to
USB communication is provided that has a 'Y' branch connector to
attach the AC power cord. This AC power is needed for charging the
battery of the handheld PC.
14
Continue to slide another eighth of an inch until completely
engaged. If the battery is not fully engaged, the system will not
operate properly.
Close the battery compartment door.
Agilent 4100 ExoScan FTIR Operation Manual