Table of Contents
Advertisement
42/68
Installation
Stud bolt (52)
Mounting of bar (51)
Bosch Rexroth Mellansel AB, Intallation and maintenance manual, Hägglunds VI, RE 15310-WA/10.2015
10. Mount the upper brake bands (5 or 7). Place screws (12), washer (13), pointer
(15) and nuts (14). Lubricate the screws prior to fitting – see paragraph 1.
Notice! The brake bands must be movable in relation to the link head. For this
reason, do not tighten the screws so much as to squeeze link head (29) together.
11. Mount the bands together with adjusting screws (10), spacers (9 and 2) and
nuts (1). Prior to mounting, grease adjusting screws (10) with Molykote G or an
equivalent.
12. Fix scale (46), support plate (47) and spacers (48) with screws (45).
13. Rivet the brake adjustment sign (64), and the braking force direction plate (917).
14. Before starting up, adjust the brake assembly. See brake adjustment for BA-43
and BA-63, single acting.
15. Place nut locks (4) and screws (3).
16. Check that the brake assembly is installed so that the correct braking force
direction is obtained, and that the signs (60 and 917) corresponds with the
installed brake assembly.
Screws (A)
M24
1" UNC
*Lubricate with oil
Installation of brake assembly BA-43, BA-63 double acting and
brake cylinder BCI-M
Stud bolt
(53)
Fig. 50:
Tightening torque*
Strength class
(ISO 898/1)
10.9
10.9
Notice! IMPORTANT!
Mounting direction with
the locking of toggle
bearing against the
washer and nut.
Alternative place
for 60 and 63
Notice: For BA-43,
spacers (11) must be
placed between the
bracket and brake bands.
Nm
lbf·ft
960
710
1 100
810
Hide quick links:
Advertisement
Table of Contents
