Installation Of Brake Assembly Ba-43, Ba-63 Single Acting And Brake Cylinder Bci-M - Bosch Rexroth Hagglunds VI 44 Series Installation And Maintenance Manual

Installation of brake assembly BA-43, BA-63 single acting and
brake cylinder BCI-M
Notice! IMPORTANT!
Mounting direction with
the locking of toggle bearing
against the washer and nut.
Fig. 49: Clockwise braking force direction
1. Mount the bushings (32) on the bracket (910 or 911), using eccentric shaft (16
or 17) as a tool. Grease the bushings with Texaco Multifak EP2 or an equivalent
grease without solid additives. Also fill the spa ce between the bushings with
grease.
2. Mount the rear shaft (56), spacer (57) and circlip (58). Grease the shaft prior to
fitting: See paragraph 1 above.
3. Locate sleeve (55) on the rear shaft. Mount the rear bracket of the brake cylinder
(925), washer (54) and nut (27).
4. Press bushing (34) into lever (41 or 42).
Notice! Make sure that the lubrication holes coincide. Insert the grease nipp le (35),
and protection cap (70).
5. Grease eccentric shaft (16 or 17) – see paragraph 1 – and insert it. Mount key
(31), lever (41 or 42) washer (28) and nut (27).
6. Mount the brake cylinder piston rod on the lever (41 or 42). Assemble screw (36)
and nut (33).
7. Mount link head (29), washer (28) and nut (27). Insert grease nipple (26), and
protection cap (70).
8. Mount the motor, see 3.1.5 "Motor – front bracket on series 44 and 64".
9. Mount the lower brake bands (6 or 8). Lubricate the journals in accordance with
paragraph 1. Assemble washers (25) and screws (A). If the screws can not be
tightened with a torque wrench, tighten until the washers (25) are flat.
Hägglunds VI, RE 15310-WA/10.2015, Intallation and maintenance manual, Bosch Rexroth Mellansel AB
Notice! For BA-43, spacers (11) must be placed
between the bracket and brake bands.
Installation 41/68