Motor - Torque Arm - Bosch Rexroth Hagglunds VI 44 Series Installation And Maintenance Manual

18/68 Installation
Bosch Rexroth Mellansel AB, Intallation and maintenance manual, Hägglunds VI, RE 15310-WA/10.2015
Mounting of valve V 46-C on 44- and 64-series motors
Before mounting of the valve, check that the motor is mounted into the bracket with
"D2" connection on the motor mounting surface facing upwards, see figure 14.
• Remove the cover on the motor mounting surface.
• Remove all plugs on the motor mounting surface.
• Mount the plug BSTP 3/4" (included in the mounting set) in the bottom of the hole
for port "A", see figure 14.
• Place the O-rings in the proper position on the valve mounting surface. Use grease
to keep the O-rings fixed.
• Mount the valve against the motor with the ports in corresponding position.
Fig. 13:
Motor mounting surface
Fig. 14:
1.1.3 Motor – torque arm
Mounting of torque arm on series 44 and 64
• Remove the cover on the motor mounting surface
• Install the torque arm on cylinder block as shown in the figure.
In the installation, connection "D
NOTICE
Motor
Cover
2-speed plug
" on the motor should be upwards.
2
Valve