EdilKamin FANTASY Installation, Use And Maintenance Manual page 30

COVERING INSTALLATION FATA/SIRENA
75
33
75
g. 1
29
138-139
g. 3
g. 5
g. 6
29
61
62
g. 8
130
24
62
62
4
g. 10
29
g. 2
g. 4
150
138
139
150
138
139
150
150
detail. "Y"
g. 7
150
61
61
150
62
150
61
61
130
150
150
g. 9
DETAIL. Z Part. "Z"
62
bushings
24
vite
screw
g. 11
INCLUDED HARDWARE:
2 M6x25 screws
2 M6x12 screws
4 silicone spacers for ceramic top
8 at washers diam. 6
2 bushings
16 silicone spacers for ceramics
2 ceramic xing plates
ASSEMBLING THE LATERAL TILES ( g. 1-2)
• Remove the rear panel (33) "And the two pro les (75).
• Fix the two plates (29) to the zinc-plated sides."
"for the FATA model (Illustr. 3-4)
150
• The left-hand plate must be xed to the central and upper
holes, whilst the right-hand plate must be xed to the central
and lower holes.
• Fit the ceramic tiles (138-139) on to the plates (29)
• Place 2 silicone-coated spacers (150) in the lower part betwe-
en the cast iron base and the lower, right-hand tile (139) (see
150
detail Y - Illustr. 4).
• For correct fastening of the upper right side ceramic tile and
the lower left side ceramic tile use the stop adjustment screws
located on the zinc-plated sides of the structure (Illustr. 5-6)
• Right-hand side (Illustr. 5): adjust the xing screw abutted
against the upper right side ceramic tile (138).
• Left-hand side (Illustr. 6): remove the upper left ceramic tile
(139) and adjust the xing screw abutted against the lower left
side ceramic tile (138).
• Replace the upper left ceramic tile (139).
for the SIRENA model (Illustr. 8-9)
• Both plates must be xed to the central and lower holes.
• Fit the ceramic tiles (61) on to the plates (29)"
NOTE: Being made through a process of casting,the tiles may
differ slightly in height. To compensate for any height varia-
tions, silicone spacers may be inserted (150 - g. 4-9) without
150
affecting the aesthetic appearance of the stove.
• Replace the pro les (75) Replace the rear panel (33).
ASSEMBLING THE UPPER FRONT PANEL FATA/SI-
RENA ( g. 10-11)
• Position the ceramic upper front panel (62) so that it rests
against the front panel support (24) positioned above the door.
• Use an Allen key to fasten the front panel in place using
the 2 supplied M6x25 screws (the door must be opened before
performing this operation).
62
NOTE: For correct assembly of the upper front panel (62), pla-
ce the bushing supplied between the same and the front panel
(24), as shown in detail "Z" in Illustr. 11.
ASSEMBLING THE LOWER FRONT PANEL FATA/
SIRENA ( g. 10-12)
• Use the supplied Allen key to loosen the screws that hold
the cast iron lower front grill (4) in place and remove it.
• Position the front panel (62) and use an Allen key to
fasten it in place using the 2 supplied M6x25 screws as indica-
ted in detail "X" ( g. 12).
- 30
-
62
62