Advertisement
PRESTIGE
Control Module
Kit Part Number:
Solo Models and Excellence)
Parts List
1. MCBA Rev. 5 Control Module (w/green dot)
2. 4 -Self-tapping Screws
Recommended tools:
-
Phillips Screw Driver.
WARNING
Indicates a potentially hazardous situation
which, if ignored, can result in serious
injury or substantial property damage.
WARNING
For your safety, turn off electrical power
supply at service panel before proceeding to
avoid possible electrical shock hazard.
Failure to do so can cause severe personal
injury or death.
MCBA
Replacement Kit
PSRKIT74 (All Prestige
MCBA Control
NOTI E
Indicates special instructions on installa-
tion, operation or maintenance, which are
important to equipment but not related to
personal injury hazards.
WARNING
Failure to follow instructions below can
result in severe personal injury or damage if
ignored.
•
Instructions are for a qualified installer/
service technician.
•
Read all instructions before proceeding.
•
Follow instructions in proper order.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TriangleTube PSRKIT74
Summary of Contents for TriangleTube PSRKIT74
- Page 1 MCBA PRESTIGE Control Module Replacement Kit Kit Part Number: PSRKIT74 (All Prestige Solo Models and Excellence) Parts List 1. MCBA Rev. 5 Control Module (w/green dot) 2. 4 -Self-tapping Screws Recommended tools: Phillips Screw Driver. MCBA Control WARNING NOTI E...
- Page 2 MCBA PRESTIGE Control Module Replacement Kit Instructions NOTI E 1. Turn power to the unit “OFF”. Note that connector X4 may have 4 pins but the wire harness connector only has 3 pins. 2. Remove the front jacket panel. The connector should be placed over pins 1 through 3.
- Page 3 MCBA PRESTIGE Control Module Replacement Kit After Parameter 4, the display will show P followed ENtERING MCBA ACCEss CodE by the parameter number. Once a particular para- The installer must enter the MCBA Access Code to meter is reached, the display will change to show adjust the advanced parameter settings of the the current setting of that parameter.
- Page 4 MCBA PRESTIGE Control Module Replacement Kit WARNING NOTI E If a parameter setting is changed but the Once a parameter setting has been revised STORE button is not pressed to save the set- and stored, pressing the STEP button will ting, the MCBA will automatically store the display the setting of the next parameter setting after 15 minutes.
Need help?
Do you have a question about the PSRKIT74 and is the answer not in the manual?
Questions and answers