Troubleshooting - Silvercrest SEMM 1470 A1 Operating Instructions Manual

Troubleshooting

Malfunction
The espresso no
longer flows out
The espresso drips
over the edges of the
sieve holder
instead of from the
openings.
The milk is not being
frothed.
The pump is
unusually noisy.
The crema is too light
(the espresso runs
out of the sieve
holder quickly)
The crema is too dark
(the espresso runs
out of the sieve
carrier slowly)
│ GB │ IE
■ 64
Cause
The espresso powder is too moist
and/or compressed too tightly.
No water in the water tank
The holes of the sieve holder
openings are blocked.
The sieve holder is not
correctly inserted.
The sieve holder openings
are blocked.
There are espresso powder residues
on the edges of the sieve holder
The "Milk quantity" knob
pointing to the " " symbol or
beyond. This means you are in
cleaning mode.
The milk tank lid and/or the
milk nozzle are blocked.
The water tank is empty.
Not enough espresso powder.
The espresso powder is too
coarsely ground.
Too much espresso powder.
The powder is too finely ground.
Remedy
Re-prepare the espresso.
However, this time do not
compress it so tightly, or
replace it completely.
Fill the water tank
.
with water.
Clean the sieve holder
Insert the sieve holder
correctly.
Clean the sieve holder
Clean the espresso powder
residues from the edges of the
.
sieve holder
Turn the "Milk quantity"
is
knob further to the left until
it points to the " " symbol to
produce milk froth.
Clean the milk tank lid
and/or milk nozzle
described in the section
"Cleaning the milk nozzle
and milk tank".
Fill the water tank
with water.
Use more espresso powder.
Use only espresso powder
that is specially produced for
making espresso.
Use less espresso powder.
Use only espresso powder
that is specially produced for
making espresso.
SEMM 1470 A1
.
.
.
as