Troubleshooting - Silvercrest 282260 Operating Instructions Manual

19) Push in the "Steam" button
20) Hold a container under the milk frother
button
lights up.
21) After about 1 minute, close the steam control
" - " as far as the stop), press the "Steam" button
the appliance.
NOTE
► If no button is pressed, the appliance turns off automatically after
30 minutes.

Troubleshooting

Malfunction
The espresso no longer
flows out.
The espresso drips over
the edges of the sieve
holder , not from the
openings.
The espresso is cold.
The pump is unusually
noisy.
■ 20 │
GB
to the position " + " as soon as the green heating-up control lamp
Cause
• The espresso powder is too
moist and/or compressed
too tightly.
• No water in the water tank
• The holes of the sieve holder
openings are blocked.
• The sieve holder
correctly inserted.
• The sieve holder openings are
blocked.
• There are espresso powder
residues on the edges of the
sieve holder .
• The appliance was not
preheated.
• The green heating-up control
lamp has not yet glowed.
• The cups were not pre-warmed. • Pre-warm the cups.
• The water tank
so that it clicks into place.
and slowly turn the steam control
(turn it in the direction of the
• Re-prepare the espresso
without compressing the
powder as firmly; if neces-
sary, use new powder.
• Fill the water tank
.
with water.
• Clean the sieve holder
is not • Insert the sieve holder
correctly.
• Clean the sieve holder
• Clean the espresso
powder residues from
the edges of the sieve
holder
• Preheat the appliance.
• Wait until the green
heating-up control
lamp
• Fill the water tank
is empty.
with water.
again and switch off
Solution
.
.
.
lights up.
SEM 1100 B3