Troubleshooting - Silvercrest SEM 1100 B3 Operating Instructions Manual

19) Push in the "Steam" button
20) Hold a container under the milk frother
button
lights up.
21) After about 1 minute, close the steam control
" - " as far as the stop), press the "Steam" button
the appliance.
NOTE
► If no button is pressed, the appliance turns off automatically after
30 minutes.

Troubleshooting

Malfunction
The espresso no longer
flows out.
The espresso drips over
the edges of the sieve
holder , not from the
openings.
The espresso is cold.
The pump is unusually
noisy.
■ 20 │ GB │ CY
to the position " + " as soon as the green heating-up control lamp
Cause
moist and/or compressed
too tightly.
openings are blocked.
correctly inserted.
blocked.
residues on the edges of the
sieve holder .
preheated.
lamp has not yet glowed.
so that it clicks into place.
and slowly turn the steam control
(turn it in the direction of the
without compressing the
powder as firmly; if neces-
sary, use new powder.
.
with water.
is not
correctly.
powder residues from
the edges of the sieve
holder
heating-up control
lamp
is empty.
with water.
again and switch off
Solution
.
.
.
lights up.
SEM 1100 B3