Cleaning The Espresso Sieves, Sieve Holder And Espresso Outlet - Silvercrest SEMM 1470 A1 Operating Instructions Manual

Cleaning the espresso sieves, sieve holder and
espresso outlet
Remove all used powder from the espresso sieves
preparation.
Clean the espresso sieves
regularly.
1) After you have prepared espresso/cappuccino/latte macchiato and removed
the sieve holder
–
Fix the espresso sieve
upwards and holding it in place.
–
Knock the espresso powder out of the espresso sieve
–
Flip the sieve blocker
–
Remove the espresso sieve
–
Clean the espresso sieve
with a little mild washing-up liquid. Rinse all the parts off afterwards
using clean water.
NOTE
2) Replace the sieve holder
sieve
3) Fill the water tank
4) Place a suitably large, empty container onto the drip grille
5) Switch the appliance on using the on/off switch
lamps light up permanently.
6) Press the "Small" espresso button
espresso outlet
coming out of the espresso outlet
NOTE
► If you want to descale the water tank
described in the section "Descaling mode".
NOTE
► You can store the sieve holder
holders
│ GB │ IE
■ 62
:
The espresso sieves
dishwasher.
.
with water (approx. 200 ml).
and rinses out the pipes. As soon as the water stops
next to the water tank
, the sieve holder and the espresso outlet
in place by flipping the sieve blocker
back down again.
from the sieve holder
and the sieve holder
are also suitable for cleaning in the
in the appliance without the espresso
. The water comes out of the
, the cleaning process is complete.
and the pipes, proceed as
and the espresso sieves
.
after every drink
.
.
in warm water
.
and wait until all control
in the
SEMM 1470 A1