Sequencer Commands; Matrix Arpeggiator Commands - Arturia MATRIXBRUTE Manual

2.8.7. Sequencer commands

Function
Change Sequence
length
Rotate Sequence
Extend & Duplicate
SEQ content
(Whole
Adjust BPM
numbers only)
Edit a Step Pitch value
(with keys)
Edit a Step Pitch value
(with Mod Amt knob)
Add a tied note / Tie
steps
Add tied note + Set
pitch
Add tied note + Set
pitch
Edit Seq step MOD
value
Disable multiple steps

2.8.8. Matrix Arpeggiator commands

Function
Enable Matrix
Arpeggiator
Enter lower approach
note
Enter upper approach
note
.
Arturia - Changes in version 2.0 - New Features: The Details
Button press combinations
Hold SEQ Length button, press a Step
button
Hold TAP + press Step < or >
Hold SEQ Length + press Step >
Hold TAP + turn Rate
Hold Seq Step + press a key
Hold Seq Step + turn Mod Amt knob
Hold two step buttons
Hold two step buttons + press a key
Hold two step buttons + turn Mod Amt
knob
Hold Seq Mod step + turn Mod Amt
knob
Hold two Steps in the same row: first
the right step, then the left step
Button press combinations
Press Sequencer
Arpeggiator
Hold Step < + Matrix button
Hold Step > + Matrix button
Description
Sets the length of the sequence
Rotates the contents of a sequence
between the first and the last step
Sequence length is doubled and content is
duplicated
Increments / decrements BPM by whole
numbers only
Modifies the step note
Modifies the step note
Add a tied note between the two held
steps
Adds a tied note + sets pitch value with a
key press
Adds a tied note + sets pitch value by
browsing notes with the Mod Amt knob
Modifies the step Mod Amt value
Disables all the steps between the two
held steps, including the held steps
Description
+
Enables Matrix Arpeggiator mode
Set the note one half step below the defined
note
Set the note one half step above the defined
note
18