Operation; Cutting Workflow; Operation Panel Description; Lcd Display Description - Intec ColorCut BC480 User Manual

• Close to heating and cooling sources
• Vibration of work surface
!
Attention
• Don't put any other electrical plug, other than what has been provided, into electrical outlet
• Prone to static - you should use static shield and humidifier
• Don't put the machine on a table that is smaller than its footprint

2. Operation

2-1 Cutting workflow

This flowchart shows you the process for machine usage.
Page 14

2-2 Operation panel description

LCD display description

Initial understanding of the LCD panel is important. Please take a little time to navigate yourself
through the buttons and display before completing any work.
!
When the BC480 is turned on it will go into the last mode used.
With the BC480 turned on and in standby press the
Mode number (0-9). The cutting mode is the preset COLUMN width size in mm and is defined by the
cassette delivered with the BC480 and ROW length - this figure is variable and dependant on the
card size you would like to cut.
Press this button to understand how the modes change and watch the card sizes change - this does
not change your sheet / paper size. The modes are explained in Section 2-4.
After pressing through the modes now press the
setup menu as shown below:
MODE
SET button. This will change your cutting
MODE
SET
for 3 seconds. This will take you into the
Page 15