System Settings; System Speed; System Accuracy Compensation - Intec ColorCut BC480 User Manual

2-5-4 System settings

Under normal circumstances the BC480 will have been set up prior to shipping and you will not have
to make any changes under the system settings.
Should you wish to only change an individual card setting please do this under the CARD OPTION
menu specific to the card mode selected.
!
Attention:
Any changes made under the system settings will change the values for all preset card modes.
These are universal changes.
The options available under the system settings are:

• System speed

• System accuracy compensation

• Five column blade (longitudinal) width - for 5 card cutting cassettes
• Three column blade (longitudinal) width - for 3 card cutting cassettes
• First cutting compensation
• Mark position compensation
• Groove width compensation
• Last card compensation
• Penultimate card compensation
• Third from last card compensation
• Subtotal clear
• Restore factory settings
• Firmware version
MODE
SET
From standby mode, press and hold the button for 3 seconds to enter the setup menu, the
LCD will display:
To navigate around the menus press the
selection. Once you have selected the System option menu press the
you to the sub menus.
To navigate around the following sub menus use the
i
To easily make changes to a measurement values and when in the menu you would like to
or buttons to move the cursor to system
MODE
SET button which will take
button.
Page 36
START
change, press the STOP and this will add a small arrow above the measurement values as shown
below. Keep pressing until the arrow falls above the measurement you want to change and use the
or buttons to change the value until you are finished.
1. System speed
This menu sets the speed of cutting of your sheets.
Changing the system speed can affect the cutting accuracy and positioning of your cuts.
The selectable options are 1-9 . 1 being the slowest and 9 the fastest setting.
As an example and using an SRA3 sheet for 85mm x 54mm cards (21 cards to cut) the system on
setting 1 will take 9 seconds to cut the sheet and on 9 it takes 7 seconds to cut the sheet.
The BC480 will have been programmed and tested prior to shipping and so the value set in this
menu should not be changed. However, if it has to be changed, we advise you do not set this to
more than 8.
If you need to change the speed setting this can be done by using the
2. System accuracy compensation
This refers to the scaling
This is set prior to shipping and should not be adjusted.
or buttons.
Page 37