Paper Feed Tray; Waste Paper Tray; Card Collection Tray; Mains Power - Intec ColorCut BC480 User Manual

Once in place and on a stable surface check contents.
The machine contains wrapped items, as listed in Chapter 2. 1-3 Accessories section, in the waste
tray.
Remove all the items and check all the contents are there.
Once you have confirmed that all the items are received please put the BC480 together as follows:

1-2 Paper Feed Tray

Find the paper feed tray and hook onto the holding pins.
The tray has adjustable feed guides that can be secured in place by tightening the screws on either
side of the tray - ensure these are closed up to your paper edges but not too tight!

1-3 Waste Paper Tray

Install the waste paper tray in the back of the machine, making sure tray is fully inserted into the
aperture.
Page 12

1-4 Card Collection Tray

Install the card collection tray onto the holders for this:
After the card collection tray has been secured in place, add the card dividers - these are magnetic
and adjustable.

1-5 Mains Power

Now put your mains power cable in its input socket and plug into a mains power source.
!
Attention: Make sure the main covers magnetic interlock switch is fully connected
In order to remove the static charge must be grounded.
!
Attention: In case of electric leakage, be careful electric shock
Make sure power switch be turned on.

1-6 Placement of machine for operation

Please use the machine in the following places:
• On a stable surface
• In a well-ventilate area
• Ensure area around the machine is free from debris
The machine is made of precision machinery and electronic components and therefore needs
to be located in a suitable place for use.
Please avoid the following locations:
• Direct sunlight
• Areas of high humidity
• Keep away from sources of ignition
• Places that can become prone to moisture
Page 13