Five Column Blade Width; Three Column Blade Width; First Cutting Compensation; Mark Position Compensation - Intec ColorCut BC480 User Manual

Press or buttons for compensation setting -3.0 to +3.0mm.

3. Five column blade width

This measurement is set prior to shipping of the BC480. Should you purchase an additional
cassette, this measurement can be changed to match the cassette size - measurements are in mm.
Press or buttons, until you reach the cassette measurement.

4. Three column blade width

This measurement should be set prior to shipping of the BC480.
Should you purchase an additional cassette, this measurement can be changed to match that
cassette size - measurements are in mm.
Press or buttons, until you reach the cassette measurement (values between 1 —
99mm).
Page 38

5. First cutting compensation

This is where the first cut is placed on your card.
When Edge Datum selection is chosen our templates will have this set to 10mm as a default.
LCD display:
If you are using different templates please set this to the measurement of where you would like your
first cut to be.
Press or button to change the measurement.
MODE
SET
Press button and return to previous menu.

6. Mark position compensation

This refers to the gap between the mark and the edge of where you want your card to be cut.
Here our example shows a 2mm gap between the 'MARK' and the edge of card to be cut.
To adjust this value press or button, until the LCD displays your required measurement.
Once your measurement is set press the

7. Groove width compensation

Your groove width is the measurement between you card rows. You can apply a compensation
to your width. This is a variable measurement and is dependant on the card template you have
selected and the therefore the card mode.
Continue to press button, until the LCD display:
MODE
SET button to return to previous menu.
Page 39