TE Connectivity GS-IPC-500U Installation Instructions

Installation Instructions
PII 408-32287
EPP-3429
REV. A
GS-IPC-500U AND GS-IPC-500U-ES
SOLAR INSULATION
PIERCING CONNECTOR
WITH POWERGEL FILLED COVER
FOR PV CABLES UP TO 1.5 kV DC
DANGER
When installing electrical power system accessories, failure to follow applicable personal safety requirements and written
installation instructions could result in fire or explosion and serious or fatal injuries.
DANGER
Working around energized high-voltage systems may cause serious injury or death. Installation should be performed by
personnel familiar with good safety practice in handling high-voltage electrical equipment. De-energize and ground all electrical
systems before installing product.
DANGER
Power distribution and transmission products must be properly selected for the intended application. It must be installed and
serviced by competent personnel who have been trained and understand proper safety procedures. These instructions are
written for such personnel and are not a substitute for adequate training and experience in safety procedures.
CAUTION
Read and understand the contents of these instructions before installation and follow all locally approved procedures and safety
practices before installing or operating this equipment.
CAUTION
These instructions cannot cover all details or variations in the equipment, procedures, or processes described, nor provide
directions for meeting every possible contingency during installation, operation, or maintenance. When additional information is
desired to satisfy a problem not covered sufficiently for the user's purpose, please contact your TE sales representative. These
instructions are not intended to supersede or replace existing safety and operating procedures.
NOTICE
Upon receipt of a product, inspect it thoroughly for damage and loss of parts incurred during shipment. If damage or loss is
discovered, file a claim with the carrier immediately or contact your TE representative.
The Information contained in these installation instructions is for use only by installers trained to make electrical power
installations and is intended to describe the correct method of installation for this product. However, TE Connectivity has no
control over the field conditions which influence product installation.
It is the user's responsibility to determine the suitability of the installation method in the user's field conditions.
TE Connectivity's only obligations are those in TE Connectivity's standard Conditions of Sale for this product and in no case
will TE Connectivity be liable for any other incidental, indirect or consequential damages arising from the use or misuse of the
products.
Raychem, TE, TE Connectivity and TE connectivity (logo) are trademarks.
© 2019 TE Connectivity. All Rights Reserved.
TE Connectivity
8000 Purfoy Road
Fuquay-Varina NC 27526
TEL: (919) 552-3811
FAX: (919) 557-8404
TE.com/energy
TE´s Connectors and Fittings