Connection; Tools; Cable Cross-Sections; Can-Connection Cable - Eaton MOELLER EC4E-221-6D4T1 Hardware And Engineering

09/08 AWB2724-1614en

Connection

To connect the digital module, use the following tools and
materials.

Tools

Chase-screwdriver, width 3.5 mm,
tightening torque 0.6 Nm.

Cable cross-sections

• Solid: 0.2 to 4 mm
2
• Flexible with ferrule: 0.2 to 2.5 mm

CAN-connection cable

The EC4P (RJ45 connection) and EC4E (screw-type
terminals) devices are connected to each other with a CAN
connection cable EU4A-RJ45-CAB2.
Figure 8: CAN connecting cable

Bus termination resistor

The physically first and last stations in the network must
each be terminated with a bus termination resistor of 120
ohms. This is done on the device back with DIP switch 1, a
figure 12 on page 21.
Connection
2
EU4A-RJ45-CAB2
17