Step 2. Remove The Front Panel Assembly - Agilent Technologies PNA Series Installation Note

Step 2. Remove the Front Panel Assembly

Refer to Figure 3 for this procedure.
1. With a 5/16-inch wrench, remove the six front panel semirigid jumper cables (item
2. With a T-10 TORX driver, remove the eight screws (item
Before removing the front panel from the analyzer, lift and support the front of
CAUTION
the analyzer chassis.
3. Slide the front panel over the test port connectors.
4. Disconnect the front panel interface ribbon cable (item
interface board. The front panel is now free from the analyzer.
Figure 3 Front Panel Assembly Removal
The figure above shows the E8363/4B front panel and floppy disk drive.
NOTE
The E8363/4C front panel has a slightly different appearance and does not
include a floppy disk drive.
8
②
) from the sides of the frame.
③
) from the A3 front panel
Installation Note E8364-90024
①
).