Table of Contents
Advertisement
Model Number:
Serial Number:
Reason for Inspection: (Check Applicable Box)
1.
Scheduled Periodic Inspection
( ______ Quarterly ______ Semiannually ______ Yearly)
2.
Discrepancies noted during Frequent Inspection
3.
Discrepancies noted during Maintenance
4.
Other:
______________________________________________________
Refer to the Parts, Operation and Maintenance Manual "INSPECTION" section for general inspection criteria. Also, refer to appropriate
National Standards and codes of practice. If in doubt about an existing condition, contact the nearest Ingersoll-Rand Distributor or the
factory for technical assistance.
COMPONENT
Arms
Fasteners
Shafts and Pulleys
Bearings
Balancer
Wire Rope Guide
Covers
Controls and Hoses
Air Manifold
Measure hook and check for increased throat opening.
Bottom
Damage
Hook
Hook Crack Test Method Used: Dye Penetrant ______ Magnetic Particle ______ Other: ________________________________
Hook Latch
Wire Rope
Working length(s) maximum stretch: _________ inches/ _________ mm
Supporting Structure
Labels and Tags
Other Components
(list in NOTES section)
This page may be photocopied and used as an Inspection/Maintenance record.
14
INSPECTION AND MAINTENANCE REPORT
Ingersoll Rand Manipulator Arm
CONDITION
Pass
Fail
Refer to Balancer Parts, Operation and Maintenance Manual.
REVIEW COPY 9-7-99
Date:
Inspected By:
Operating Environment:
Normal _______ Heavy _______ Severe _______
CORRECTIVE
Repair
Replace
---
---
---
---
---
NOTES
MHD56162 - Edition 1
Advertisement
Table of Contents
