Table of Contents
Advertisement
Lash-Up
To properly install load hook to wire rope you must determine the
following:
1.
Highest point which load must clear from floor. Refer to
Dwg. MHP1358 on page 10.
#1
(Dwg. MHP1358)
2.
Distance from hook throat to bottom of load. Refer to Dwg.
MHP1896 on page 10.
3.
Add dimension #1 to dimension #2, then add 3-1/2 inches (89
mm).
4.
Measuring from the floor with the wire rope fully retracted,
install hook using the dimension from instruction #3 to the
floor.
(Dwg. MHP1896)
10
Obstruction
Load
#2
REVIEW COPY 9-7-99
Yarding
• Do not operate the unit if load is not centered under wire
rope. Yarding of the wire rope will cause premature wire rope
failure and undue wear of unit parts.
Wire rope should not be yarded more than 10 degrees in any
direction from the center line of the wire rope guide or pulley.
Excessive yarding will cause increased wear on the unit and may
decrease the working life of the components.
Incorrect
Correct
(Dwg. MHP1897)
10 Degree
Maximum
angle in
any direction
MHD56162 - Edition 1
Advertisement
Table of Contents
