Contents 1 Preliminary note ���������������������������������������������������������������������������������������������������3 1�1 Symbols used ������������������������������������������������������������������������������������������������3 2 Safety instructions �����������������������������������������������������������������������������������������������3 3 Functions and features ����������������������������������������������������������������������������������������3 3�1 Applications ���������������������������������������������������������������������������������������������������4 4 Installation������������������������������������������������������������������������������������������������������������4 4�1 Use as a level sensor ������������������������������������������������������������������������������������4 4�1�1 Installation on tanks with a mounting adapter ��������������������������������������4 4�1�2 Installation on bybass pipes with a mounting adapter ��������������������������5 4�2 Use as proximity sensor ��������������������������������������������������������������������������������6 4�2�1 Installation and installation remarks �����������������������������������������������������6 4�2�2 Mounting adapter bore hole dimensions ����������������������������������������������7...
1 Preliminary note 1.1 Symbols used • An instruction is indicated by "►": Example: ► Mount the unit as shown. • A reaction to the action is indicated by ">": Example: > yellow LED lights. Important note Non-compliance can result in malfunctions or interference� Information Supplementary note�...
3.1 Applications 4 Installation 4.1 Use as a level sensor 4.1.1 Installation on tanks with a mounting adapter The mounting adapter is to be ordered separately (order no� E12153)�...
Figure A ► Place the sensor with the lower part (1) into the mouting adapter� The sleeves of the mounting adapter must engage with the lower cutouts of the sensor� ► First slightly press the lower part of the sensor� ►...
► Fix the sensor to the bypass at the requested height with common cable ties� Insert the cable ties through the existing openings of the mounting adapter and tighten them firmly� 4.2 Use as proximity sensor 4.2.1 Installation and installation remarks without mounting adapter with mounting adapter 1: sensing face...
4.2.2 Mounting adapter bore hole dimensions Do not place the mounting adapter including inserted sensor in the immediate vicinity of metallic objects� 4.2.3 Installation without a mounting adapter ► Fix the sensor at the intended location using suitable screws or a suitable glue� ►...
4.2.4 Sensor bore hole dimensions 5 Electrical connection The unit must be connected by a qualified electrician� The national and international regulations for the installation of electrical equipment must be adhered to� ► Disconnect the installation from power and connect the unit. 5.1 Wiring p-switching (types FPKG���...
7 Settings The following chapter applies only to units with the article number KQ51xx� 7.1 IO-Link This unit has an IO-Link communication interface which enables direct access to process and diagnostic data� In addition it is possible to set the parameters of the unit while it is in operation�...
10 Terms Active zone Area above the sensing face in which the sensor reacts to the approach of the target� Output function Normally open: object within the active zone - output switched. Normally closed: object within the active zone - output blocked. Programmable: Choice between normally closed or normally open.
Page 11
Technical data and further information at www�ifm�com...