Model 14 Bin Vibrator Mounting Instructions - A-Maize-Ing Heat NRP620-10 Owner's Manual

Model 14 Bin Vibrator Mounting Instructions

1. Place the PBH1A01A Model 14 Bin upside down on supports.
2. Place the Mounting Hole Template (shown on page 23) on the largest outside bottom section of
the PBH1A01A Model 14 Bin with the "HOPPER SPOUT" indicator against the bin hopper spout.
3. Drill 3/16" mounting holes in the two locations indicated by the template.
4. Remove the NI-2016 4 X 4 Box Flat Lid from the VIB1A01A Vibrator Assembly.
5. Remove the two NI-2012 #8-32 Hex Lock Nuts and NI-1062 3/16" X 1 1/2" Fender Washers
from the bottom of the VIB1A01A Vibrator Assembly.
6. Orient the VIB1A01A Vibrator Assembly on the outside of the PBH1A01A Model 14 Bin so the
flex conduit is closest to the fuel spout.
7. Mount the VIB1A01A Vibrator Assembly to the PBH1A01A Model 14 Bin by passing the NI-1045
11/32" X 2 1/2" Machine Bolts through the holes drilled.
8. Secure the VIB1A01A Vibrator Assembly to the PBH1A01A Model 14 Bin with the two NI-2012
#8-32 Hex Lock Nuts and NI-1062 3/16" X 1 1/2" Fender Washers from the bottom of the
VIB1A01A Vibrator Assembly.
9. Replace the NI-2016 4 X 4 Box Flat Lid on the VIB1A01A Vibrator Assembly.
NRP620-10 OMEPAPV20161017 (ENGLISH) REV 1
Page 22 of 42