Vibrator Mounting Instructions - A-Maize-Ing Heat NRP620-9 Installation Manual

VIBRATOR MOUNTING INSTRUCTIONS

1. Drill two 3/16" mounting holes 2 inches apart in the center of the long angle of the hopper
bin. (See figure 1)
2. Mount vibrator to the hopper using the holes drilled. Open face of J box facing away from
hopper body. (See figure 2)
3. Secure the vibrator to the hopper with fender washers and lock nuts on the inside of the
hopper. (See figure 3)
4. Connect the flex conduit to the bin auger motor housing.
5. Connect the vibrator red wire to the red wire in the auger motor housing and the white
vibrator wire to the black and two white wires in the hopper feed auger motor housing.
NRPIM620-9-20131212 Rev 1
Figure 1
Figure 3
Figure 2
Page 15 of 24