A-Maize-Ing Heat NRP620-10 Owner's Manual page 66

2. Install auger assembly by sliding auger boot (with clamp) under PBH1A01A Model 14 Bin
outlet; align elbow on BUF1A02A Model 14 Bin Auger tube directly over the BAA1A01A Burner
Auger Assembly fuel inlet. Tighten auger boot clamp securely. It is advisable to install two
sheet metal screws through the clamp, auger boot, and into the hopper bin outlet to ensure a
permanent connection.
3. Remove cover from BUF1A02A Model 14 Bin Auger box.
4. Fasten the flex conduit from the VIB1A01A Vibrator Assembly to the BUF1A02A Model 14 Bin
Auger box through the open knockout using the conduit locknut.
5. Fasten flex conduit extending from the BUF1A02A Model 14 Bin Auger box to the BAA1A01A
Burner Auger Assembly box using the conduit lock nut.
6. Secure the fuel delivery coupler between BUF1A02A Model 14 Bin Auger tube and BAA1A01A
Burner Auger Assembly inlet.
7. In the BAA1A01A Burner Auger Assembly:
a. Connect one black bin auger motor lead to the two red wires with an orange wire nut.
b. Connect one black auger motor lead to the two white wires with an orange wire nut.
c. Connect the two orange wires with an orange wire nut.
8. In the BUF1A02A Model 14 Bin Auger housing:
a. Connect the two red wires with an orange wire nut.
b. Connect one black auger motor lead to the two white wires with an orange wire nut.
NRP620-9 OMEPAPV20161017 (ENGLISH) REV 1
Page 21 of 42