ADJ MEGA TRI BAR User Instructions page 7

OPERATING INSTRUCTIONS (continued)
1. Plug the fixture in and press the MODE button until "SU.XX" is displayed, press SETUP. "XX" =
00-31 which is adjustable sound sensitivity levels.
2. The fixture will now change via sound. You can adjust the sound sensitivity by pressing the UP
and DOWN buttons. The sound sensitivity can be adjusted from 00 - 31, 00 being the least
sensitive, and 31 being the most sensitive.
Master-Slave Operation:
This function will allows you to link units together to run in a Master-Slave mode. In Master-Slave
operation one unit will act as the controlling unit and the others will react to the controlling units
built-in programs. Any unit can act as a Master or as a Slave however, only one unit can be
programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR
microphone cables to link your units together. Remember that the Male XLR connector is the
input and the Female XLR connector is the output. The first unit in the chain (master) will use the
female XLR connector only. The last unit in the chain will use the male XLR connector only.
2. Using the Master unit, choose your desired mode or program and connect the "Slave" unit or
units.
3. On the "Slave" unit(s) press the MODE button until "SLAv." is dis- played. They will now follow
the "Master" unit.
DMX Mode:
Operating through a DMX controller give the user the freedom to create their own programs
tailored to their own individual needs. This fixture has 7 DMX Channel Modes.
1. This function will allow you to control each individual fixture's
traits with a Elation® DMX 512.
2. To run your fixture in DMX mode, plug in the fixture via the XLR connections to any standard
DMX controller.
3. Press the MODE button until "d.XXX" is displayed. Press the UP or DOWN buttons to select
your desired address. Once you have set your desired DMX address press the SETUP button to
choose your desired DMX mode.
4. When you press the SETUP button until "d-PX" is displayed. "X" represents the current DMX
mode. Press the UP or DOWN buttons to select your desired DMX mode.
d-P1 is 2 Channel mode
d-P2 is 3 Channel mode
d-P3 is 4 Channel mode
d-P4 is 6 Channel mode
d-P5 is 7 Channel mode
d-P6 is 12 Channel mode
d-P7 is 54 Channel mode
5. Please see pages 10-17 for the DMX values and traits.
A.D.J. Supply Europe B.V. – www.americandj.eu – Mega Tri BAR Instruction Manual Page 7