Installing The Driver - Compaq StorageWorks Installation Manual

2–2 Compaq StorageWorks PCI-to-Fibre Channel Host Bus Adapter for IBM AIX Installation Guide

Installing the Driver

The driver is contained on the CD-ROM provided in your package contents. The driver
was designed to be installed from writable media and will need to be copied to a
temporary hard disk location.
To install the driver in your host system:
1. Place the CD in your host system's CD-ROM drive.
NOTE: Be sure you have a mount point, usually a directory in root, such as /mnt, and you know
the device number of the CD-Rom drive, such as /dev/cd0.
2. Mount the CD-ROM and enter the following command:
# mount -v cdrfs -r /dev/cd0 /mnt
3. To change directories to the location of the driver, enter the following command:
# cd /mnt/fcdriver/pci
4. To create a directory to load the driver enter the following command:
# mkdir /tmp/fcdriver
5. To copy the driver image enter the following command:
# cp PC1000.image /tmp/fcdriver
6. To change directories enter the following command:
# cd/ tmp/fcdriver
7. Install the driver by entering the following command:
#installp -acd PC1000.image.all