Dell UltraSharp UP2718Q User Manual page 48

Activate the computer and wake up the monitor to gain access to the OSD.
If you press any button other than the power button, the following messages will appear
depending on the selected input:
When user try to change preset mode when Smart HDR is ON, the following message
will show:
If any B/L zone operate > 90% duty cycle for 30min continuously, will turn off B/L local
dim/boost for 30min. When the local dimming is disable,the following messages will
appear on screen for 3 seconds:
If either DP, mDP, HDMI1 or HDMI2 input is selected and the corresponding cable is not
connected, a floating dialog box as shown below appears.
48 | Operating the Monitor
Dell UltraSharp 27 Monitor
No DP signal from your device.
Press any key on the keyboard or move the mouse or wake it up.
If there is no display, press the monitor button again to select
the correct input source.
Dell UltraSharp 27 Monitor
Currently processing HDR content...
To change preset mode, stop playing the HDR content.
Alternatively, switch o the Smart HDR function in Display settings.
Dell UltraSharp 27 Monitor
Backlight Local Dimming is Disabled.
Dell UltraSharp 27 Monitor
No DP Cable
The display will go into Power Save Mode in 4 minutes.
www.dell.com/support/monitors
or
UP2718Q
UP2718Q
UP2718Q
UP2718Q