3� Instrument Start; 3�1 Instrument Information; 3�2 Selecting Location / Operator - Honeywell Impact Series Operating Instructions And Maintenance Manual

3� Instrument Start-up
3�1 Instrument Information
After turning the instrument on it will display the information in the following auto
sequence (depending on model):
The first display identifies the model. While this is shown the alarms are tested and,
if a vibrating alarm is fitted this is also activated.
Language
English
Francais
deutsch
Italiano
Español
Language
Francais
deutsch
Italiano
Español
Nederlands
is set to monitor, the sensors fitted and when calibration is due.
Flammable Gas
Methane
O2 FLM
CO H2S
Calibration Due
in 120 days
Catalytic Sensor
Location
Default Location
Operator
Default Operator
� - OK
- Change
If these are acceptable then press the 3 button. Otherwise select a new location
and/or operator by pressing the
seconds, the instrument will automatically proceed to the next stage in the power-up
sequence.
3�2 Selecting Location / Operator
To change the location and/or operator press the
the current location. Press the s and t buttons to cycle through the list. Once the
correct location has been found then press 3, and follow the same procedure to
select the operator.
Impact / Impact Pro / Impact Pro IR Operating Instructions
Honeywell
Impact Pro
A Language Selection Screen is then shown (first use
only). Use the s and t buttons to highlight the required
language and press the 3 key to make the selection. Note
that some of the languages may be 'off screen' - use the
s and t buttons to access these.
The language can be changed at a later time, if required.
See Section 4.7.6 for details.
The display then shows the gas that the flammable sensor
IR Sensor (CH
The instrument logs data on the operator's exposure,
if any, to measured gases. It achieves this by
requesting the operator to confirm his/her identity
and the location where the instrument is being used.
The screen displays the last location and operator.
button. If the
Honeywell
OR
Flammable Gas
CH4
O2 CH4
CO H2S
Calibration Due
in 120 days
)
4
button is not pressed within five
button and the display will show
Impact
Flammable Gas
------
O2
CO
Calibration Due
in 120 days
IR Sensor (CO
CO2
H2S
)
2
21