Sub-Zero Wolf 500 Series Service Manual page 18

COMPONENT INFORMATION
Ice Maker Auger Motor Assy. - Model 590
WARNING
Always disconnect electrical power to equip-
ment before attempting repairs.
1. To access the ice auger motor, lift up and
remove the freezer utility rack
then remove the top light diffuser. Remove
the ice bucket.
2. Remove the front evaporator cover
45). It is secured with two screws on top and
two screws on the bottom.
3. Remove the four screws and motor bracket
(Figure 2-48).
4. Disconnect the motor leads and switch wiring
harness (Figure 2-49).
5. To reassemble, reverse steps 1 - 4.
Water Valve Solenoid - Models 501F, 511,
532, 542, 550,561
The water valve is mounted to a bracket behind
the kickplate at the left hand side
WARNING
Always disconnect water to the unit and turn
electrical power off at the master power switch
before attempting repair.
1. To access and remove the water valve, first
remove the kickplate.
2. Loosen the mounting screw which secures the
valve retainer plate.
3. Push valve up and back.
4. Disconnect electrical leads and inlet and outlet
water lines.
(Figure 2-44),
(Figure 2-
(Figure 2-50).
2-18
Model 590
Auger Motor Bracket
Screw
Figure 2-48. Auger Bracket
Model 590
Figure 2-49. Auger Motor Assy.
Models 501F, 511, 532, 542, 550, 561
Figure 2-50. Water Valve Solenoid
Screw
Drive Yoke Assy.
Motor Leads
Screw
Retainer Plate