ICC ETH-1000 Installation Manual page 41

Code
194 Invalid ignite failure response setting
195 Invalid ignite failure retries setting
196 Invalid ignition source setting
197 Invalid interlock open response setting
198 Invalid interlock start check setting
199 Invalid LCI enable setting
200 Invalid lightoff rate setting
201 Invalid lightoff rate proving setting
202 Invalid Main Flame Establishing Period time
203
204 Invalid NTC sensor type setting
205 Invalid Outlet high limit response setting
206 Invalid Pilot Flame Establishing Period setting
207 Invalid PII enable setting
208 Invalid pilot test hold setting
209 Invalid Pilot type setting
210 Invalid Postpurge time setting
211 Invalid Power up with lockout setting
212 Invalid Preignition time setting
213 Invalid Prepurge rate setting
214 Invalid Prepurge time setting
215 Invalid Purge rate proving setting
216
217
218 Invalid Stack limit enable setting
219 Invalid Stack limit response setting
220
221
222
223
224 Invalid DHW demand source setting
225 Invalid Flame threshold setting
226 Invalid Outlet high limit setpoint setting
227 Invalid DHW high limit setpoint setting
228 Invalid Stack limit setpoint setting
229 Invalid Modulation output setting
230 Invalid CH demand source setting
231 Invalid Delta T limit delay setting
232 Invalid Pressure sensor type setting
233 Invalid IAS closed response setting
234 Invalid Outlet high limit enable setting
235 Invalid Outlet connector type setting
236 Invalid Inlet connector type setting
237 Invalid DHW connector type setting
238 Invalid Stack connector type setting
239
BACnet / Boilers
Table 37. Lock and Hold Codes
Description Recommended Troubleshooting of Lockout Codes
1.
reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
1.
reset module.
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
41