Motorola MBX Series Installation And Use Manual page 50

VPD and ENV Commands
4
4-4
address, its contents are evaluated and repositioned in memory as
appropriate for the load image type (ELF, ROMBOOT, or binary).
Binary Program Load Address = 00080000?
Defines the address to which binary images are moved for execution.
Binary images are distinct from ELF or ROMBOOT images. This
parameter does not affect the load address for ELF or ROMBOOT
images.
Binary Program Execution Offset = 00000100?
Defines the offset from the Binary Program Load Address that you use
to establish the initial instruction pointer value for binary images. This
parameter does not affect the initial instruction pointer for ELF or
ROMBOOT images.
Primary Network Controller LUN = 20?Primary
Network Device LUN = 00?
These two parameters jointly define the network device that is to be
considered the primary network controller in the system. The
networking parameters for the primary network controller are saved
within the primary network controller NVRAM area.
Firmware Command Buffer:['NULL' terminates entry]?
The firmware command buffer contains EPPCBug commands that are
executed upon system startup. The commands you place in the buffer
should be typed just as you would enter commands from the command
line. Typing NULL (all uppercase) on a new line terminates the
command line entries.
In the command line buffer, you can enter all EPPCBug commands
except DU, ECHO, LO, PA, TA, and VE. The PL command should
not be used within the firmware command buffer to execute an
EPPCBug commands file.
There is no support for interactive editing of the startup command
buffer. If changes to an existing set of startup commands are necessary,
you must enter a new set of commands with changes.
Computer Group Literature Center Web Site