Motorola MBX Series Installation And Use Manual page 24

Installation Procedures
1
Warning
Warning
Caution
!
Caution
Caution
Caution
ESD
Use ESD
Wrist Strap
1-4
begin. Similarly, if you intend to connect an external battery to power the
keep-alive circuits on the MBX, you should do so at the time you install
the MBX board (see Connecting an External Battery on page 1-10
instructions).
To install the MBX board in your enclosure, refer to
for the location of connectors and jumper headers and follow the steps
below.
You need a Phillips screwdriver for this procedure. Depending on how the
user-supplied board-to-chassis standoffs are installed, you may also need a
hex nut driver, typically 3/16 inch.
You will also need cables and connectors as appropriate for your
application.
To prevent serious injury or death from dangerous voltages, use extreme
caution when handling, testing, and adjusting this equipment and its
components.
Inserting or removing modules with power applied may result in damage
to module components.
Avoid touching areas of integrated circuitry; static discharge can damage
circuits.
Attach an ESD strap to your wrist. Attach the other end of the ESD strap
to an electrical ground. (Note that the system chassis may not be grounded
Figure 6-1 on page 6-2
Computer Group Literature Center Web Site
for