Motorola MBX Series Installation And Use Manual page 35

Embedded controller version b
Table of Contents

Advertisement

Warning
Lithium batteries incorporate flammable materials such as lithium and
!
organic solvents. If lithium batteries are short-circuited or exposed to high
temperature or pressure, they may burst open and ignite, possibly resulting
Warning
in injury and/or fire. When dealing with lithium batteries, carefully follow
the precautions listed below in order to prevent accidents.
Caution
Danger of explosion if battery is replaced incorrectly.
!
Replace battery only with the same or equivalent type recommended by the
Caution
equipment manufacturer. Dispose of used batteries according to local
regulations and manufacturer's instructions.
Caution
Avoid touching areas of integrated circuitry; static discharge can damage
circuits.
Caution
Attach an ESD strap to your wrist. Attach the other end of the ESD strap
ESD
Use ESD
to an electrical ground. (Note that the system chassis may not be grounded
if it is unplugged.) The ESD strap must be secured to your wrist and to
ground throughout the procedure.
Wrist Strap
1. To remove the battery from the module, carefully pull the battery from
the socket.
2. Before installing a new battery, ensure that the battery pins are clean.
http://www.motorola.com/computer/literature
Do not short-circuit.
Do not disassemble, deform, or apply excessive pressure.
Do not heat or incinerate.
Do not apply solder directly.
Do not use different models, or new and old batteries together.
Do not charge.
Always check proper polarity.
Replacing Lithium Batteries
1-15
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents