Table of Contents
Advertisement
Quick Links
DST 4-way DMX Splitter
Instruction Manual
Models:
DST4-3, DST4-5
DST4-C
version 1.0 since 3 February 2020
ATTENTION!
This instruction manual contains important information about the installation and the use of
the equipment. Please read and follow these instructions carefully.
Always ensure that the power to the equipment is disconnected before opening the
equipment or commencing any maintenance work.
DST4_en_manual_M080
( 1 / 4)
Advertisement
Table of Contents
Related Manuals for SRS Lighting DST Series
Summary of Contents for SRS Lighting DST Series
- Page 1 DST 4-way DMX Splitter Instruction Manual Models: DST4-3, DST4-5 DST4-C version 1.0 since 3 February 2020 ATTENTION! This instruction manual contains important information about the installation and the use of the equipment. Please read and follow these instructions carefully. Always ensure that the power to the equipment is disconnected before opening the equipment or commencing any maintenance work.
- Page 2 IMPORTANT SAFETY INFORMATION The following general safety precautions have to be observed during all phases of operation, service, and the repair of this equipment. Failure to comply with these precautions or with specific warnings in this manual violates safety standards of design, manufacture, and the intended use of this equipment. Do not operate in an explosive atmosphere! Do not operate this equipment in the presence of flammable gases or fumes.
- Page 3 Front panel: Rear panel: Device in use / service: By default, Power LED indicates the device is on main power. When the Power LED is off, check the main power input. When this does not solve the problem, please call service first and then open DST4 and check fuses on the main board. When the DMX cable is connected to the device, LEDs marked as D+ and D- go on for the side marked as DMX input, thru and this indicates that DST4 is receiving the DMX signal.
- Page 4 Technical data Main input: Weight: AC 100-255V / 50-60Hz / 5W 1.7 kg DMX Input / Output: Temperature of use: 4x USITT DMX512 /RS485/ isolated up to 1000V -10 ºC… +45 º C Maximum of: 4x 32 devices per one splitter output Cable length: max: 4x 1200m Warranty: Life-time...
Need help?
Do you have a question about the DST Series and is the answer not in the manual?
Questions and answers