SRS Lighting DSR10ABN Instruction Manual

10-way dmx splitter with a/b line selection

10-way DMX Splitter with

A/B Line Selection

Instruction Manual

Models:

DSR10ABN

version 1.0 since 19 June 2017

ATTENTION!

This instruction manual contains important information about the installation and the use of

the equipment. Please read and follow these instructions carefully.

Always ensure that the power to the equipment is disconnected before opening the

equipment or commencing any maintenance work.

DSR10ABN_en_manual_M065

( 1 / 1)

Table of Contents

Need help?

Do you have a question about the DSR10ABN and is the answer not in the manual?

Page 1 10-way DMX Splitter with A/B Line Selection Instruction Manual Models: DSR10ABN version 1.0 since 19 June 2017 ATTENTION! This instruction manual contains important information about the installation and the use of the equipment. Please read and follow these instructions carefully.
Page 2 IMPORTANT SAFETY INFORMATION The following general safety precautions have to be observed during all phases of operation, service, and the repair of this equipment. Failure to comply with these precautions or with specific warnings in this manual violates safety standards of design, manufacture, and intended use of this equipment.
Page 3 When the DMX cable is connected to the device, all LEDs marked as D+/D- or the sign of signal polarity go on. This indicates that DSR10ABN is functioning properly and is retransmitting the input to the outputs. If any of LEDs is off, check the cable first – short circuit on a line causes the respective LED is off.
Page 4 Address of producer: Rybnicna 36/D, SK- 83106 Bratislava, Slovak Republic Declares that the product Name of product: 10-way DMX splitter with RJ45 connectors Type: DSR10ABN Corresponds to the following product specifications: Safety: EN60065, resp. EN 60950 EMC: EN55103-1, resp. EN55103-2 Additional information: Unit and all connected apparatuses must be earthed via main cable.