Table of Contents
Advertisement
62
1.
Open the cover following the steps from Opening cover section on page 54. Plug the
PCIe card into the appropriate PCIe slot and fasten in place using the PCIe faceplate
screws.
2.
If no further changes are required, install the G500 cover following the steps from
Closing cover on page 57.
3.
After closing the G500 cover, tighten all heat contact screws that now correspond to
occupied PCIe slots.
For screw torque specification, refer to "General Torque Values for Screws" on page 79.
GE INFORMATION
CHAPTER 4: INTERFACES
G500 SUBSTATION GATEWAY INSTRUCTION MANUAL
Hide quick links:
Advertisement
Table of Contents
