Features & Controls; Icon Touch Controls - Zephyr Roma Groove Use, Care And Installation Manual

ZEPHYRONLINE.COM

ICON Touch Controls

Power / Delay O
1 POWER / DELAY OFF BUTTON
Power Button Function
- Button will turn power on and o for entire hood (fan and lights).
- Hood will remember the last speed and light level it was turned o at.
(Example: Press
Press Button again and the hood will turn back on at speed 4 and high lights
level.)
Delay O Button Function
- With the fan on press and hold the
to speed 1 and the 5 minute delay o timer will start.
+
accordance with the time remaining until the fan and lights automatically turn
o .
- Pressing Button while Delay O Function is enabled will turn the hood o and
cancel the Delay O Function.
ACT™ Verification
- Airflow Control Technology (ACT™) allows the installer to set the maximum fan
CFM to align with local codes and regulations.
- To verify the maximum fan CFM:
- With hood o , hold the
indicators illuminate = default maximum CFM. If four fan speed indicators
illuminate = 390 maximum CFM. If 3 fan speed indicators illuminate = 290
maximum CFM.
2 SPEED SELECTION BUTTON
Fan Speed Decrease Button
- Press this button to decrease fan speed. 5, 4, 3, 2, 1.
- If fan is On Speed 1 and this button is pressed, fan will power O .
Fan Speed Increase Button
- Press this button to increase fan speed. Fan On, 1, 2, 3, 4, 5.
- If hood is O and this button is pressed, fan will turn On Speed 1.
ACT™ Enabled Speed Selections
- When ACT™ is enabled, the number of fan speeds will be reduced as follows:
- 390 CFM = Maximum 4 speeds
- 290 CFM = Maximum 3 speeds
Roma Groove Use, Care, and Installation Guide
Adjust 5 Speed Levels
Display (speed level, delay o , filter clean/change)
Button to turn o hood when on fan speed 4 and high lights.
Button for two seconds. The fan will change
LEDs will illuminate and slowly blink in
Button for two seconds. If all five fan speed
Features & Controls
Lights Low/High/O
21