Table of Contents
Advertisement
12 | ENCAPSULANT MIXING INSTRUCTIONS | GEOKON
3.
ENCAPSULANT MIXING INSTRUCTIONS
1.
Open the Shake N' Seal® container and remove the contents.
Note: Do not open the bag containing the mixing tube until you perform steps
2-6 below.
2.
Wear disposable gloves.
3.
Point the heat-sealed end of the mixing tube away from you.
4.
Flip the white barrier wafer inside the mixing tube with the thumb and
forefinger to allow the two part encapsulant to mix.
5.
If the temperature is at least 65 °F, shake the mixing tube with an up and
down motion for the duration indicated below.
Note: DO NOT SHAKE the mixing tube if the temperature is below 65 °F.
Temperature
°
Below 65
F
°
°
Between 65
F and 85
F
°
°
Between 86
F and 100
F
6.
Remove the mixing tube from the bag.
7.
Cut the heat-sealed wide end of the tube.
8.
Remove the white wafer from the tube using the provided wooden paddle.
9.
Stir vigorously with the paddle for one minute to help blend the two
components.
Once the encapsulant is mixed, do the following
1.
Position the splice tube vertically, fixed end down.
2.
Pour the mixed encapsulant out the opened, heat-sealed end of the mixing
tube into the splice tube, stopping when the encapsulant is approximately 19
mm (¾ inch) from the open end of the tube.
3.
Take the removable end cap and slide it into the splice tube.
4.
Secure the end cap to the tube by reinstalling the three #10-32 x 3/8" hex
socket head cap screws.
5.
Keep the splice tube vertical during the curing process.
Mix Time
Do not shake; instead, proceed to step 6 below.
Shake for one minute
Shake for 30 seconds
Advertisement
Table of Contents
