Channel Banks Overview - LG Pro:Centric 24LT572M Setup Manual

Express Script (Cont.)
(Continued from previous page)
8. As the final step of the Express Script, the TV saves your settings and uses the channel/Aux
input lineup to create an FTG Channel Map before configuring the TV for FTG Mode via CPU
(see also notes below). When you are ready to proceed, select Finish, and then press OK.
Express Script
Step 8. Complete the Express Script
This step uses the auto-tuned/edited channel lineup to create an FTG Channel Map and
configure the TV's CPU for FTG operation.
If you did not run Auto Tuning, no digital or analog channels will be included in the FTG
Channel Map upon completion of this step. In this case, only the Aux inputs from the
channel lineup will be included in the FTG Channel Map.
Select 'Finish' to complete the Express Script.
Saving data... 0%
Back
PTC: V#.##.### CPU: V##.##.##.## ASIC: D279
Configuration progress will be shown at the bottom of the screen. When this step is complete, the
Express Script exits, and the TV tunes to the first channel in the FTG Channel Map. Also when the
Express Script is complete, the TV is set for Channel Bank 1. If required, you can set up/modify
channel banks at a later time using LG's Cloud Configuration Tool. See "Channel Banks Overview"
below for further information.
Note: If desired, the TV Setup created from the Express Script may also be saved to a USB
memory device and used for cloning purposes (see "Cloning Procedures" on pages 50 to 55 for
further information).
Note: Aux inputs (if enabled) will appear between the highest analog and lowest digital channel
number in the FTG Channel Map when Channel Up/Down is used on the Installer Remote.
Note: If you did not run Auto Tuning and all Aux inputs are disabled, an FTG Channel Map will
NOT be created and the TV will not be configured for FTG Mode via CPU.

Channel Banks Overview

Channel Banks enable institution administrators to create tiered channel programming on patient
in-room TVs. Each channel bank may offer a custom channel lineup for a pre-determined fee.
The Express Script enables you to configure four channel banks (1, 2, 3, and 4) for the channel
lineup (see step 6 of procedure above). The top tier generally contains the most programming
(premium, etc.), 2nd tier = lesser programming, 3rd tier = basic programming, etc. It is also
possible to create an Inactive TV display with Channel Bank 4, so that an "Inactive TV Call
Attendant" message appears when the TV is turned ON. In this case, an administrator can then
select another channel bank on the patient's in-room TV depending on the programming tier
requested by the patient.
All channels found during Auto Tuning, as well as all enabled Aux inputs, automatically are added
to and active in all four channel banks. See "Channel Attributes and Channel Bank Allocation"
below for further information. If you would like to modify channel banks after completing the
Express Script (or after enabling Hospital Mode by setting Installer Menu item 027 accordingly),
you can save (export) the FTG Channel Map to a USB memory device and then use the Cloud
Configuration Tool to make the required changes (see also "Updating Channel Attributes and/or
Channel Bank Allocation" below).
28
8
1 ► 2 ► 3 ► 4 ► 5 ► 6 ► 7 ►
Finish
OK Exit
CC
206-4342