Table of Contents
Advertisement
gramming tone
Each time you touch a pad you will hear a tone. If you don't hear a tone, it is because
the
instruction
is not correct, or because
the tones have been removed.
EXAMPLE:
If you touch a Number
Pad before you touch a Command
Pad, you will not
hear a tone. The instruction
is not correct.
If you want to remove the
If you want to replace the
If you want to remove all
programmlng
tone:
programmlng
tone:
tones, except the mlnute
l
Open the door.
l
Open the door.
timer slgnal:
l
Touch CANCEL
twice,
then
l
Touch CANCEL lwlce,
then
l
Open the door.
touch START.
touch START.
l
Touch CANCEL
twice,
touch
l
The tone will not sound for
l
The tone will sound for any
0, then touch START.
any
touch.
correct
touch.
l
All audible
tones will be
cancelled.
l
To replace the tones,
Setting the clock
repeat
the above
steps.
When the oven is first plugged
in, a tone sounds and the display
shows 88:88. If the
electric
power ever goes off, the display
will again
show all 8's when the power comes
back on.
You can cook or use the Minute Timer without setting the'clock,
but the display
will be
blank after cooking,
however
AUTO START will not work unless the clock
is set.
DO THIS...
. m
1. Touch CLOCK SET.
2. Touch Number Pads for the
correct time of day.
3.
Touch START.
THIS HAPPENS...
The Display
will show a "0" and
the colon will start to flash.The
first Number Pad must be touched
wlthln 5 seconds or the Display will
go blank.
Touch CLOCK SET again
and continue.
The Display
will show what numbers
you touched
in the order you
touched them.
This example
shows
3:25.
The colon will stop flashing. The Clock
is set.
If you have touched
in an incorrect
time, such as12:65, "Err" will show on
the Display. Touch CLOCK SET and
start over.
NOTE: To mtthe
clock, touch CLOCK SET. The current time will show on the Dlspiay
and the colon will flash. Set the clock as shown above.
Advertisement
Table of Contents
